Questions & Answers for: Subaru Legacy connect on line

After market installation Hey, I'm trying out an aftermarket part that requires connection into a primary vacuum line. Clearly, I'm not going to mess with the one going to the brakes; but beyond that,

need to replace the brake line that runs from the rear passenger side caliper to the frame where it connects to the rest of the brake line. i think its about 12 inches long you can buy brake line at a

...brake line that runs from caliper to frame needs replaced i need to replace the brake line that connects to the rear passenger caliper and runs to the frame where it connects to the rest of the ...

2000 Subaru Outback wont start.. no fuel. 2000 Subaru Outback, one day decides not to start. no fuel in fuel lines, the relay seems to be fine, the pump pumped fine when i connected a 12v source to it

...and ground cables are firmly attached to the battery. Check main power wiring and chassis ground connections are all firmly attached, and fusible link (or in line maxi fuse) connections are not ...

the intake runners on your right when your looking in that area then they make a 90 degree turn and connect to rubber fuel lines that go straight to the filter. I hope this info helps...(subytech1)..

...fluid is lost during a radiator change, but all you need to do is to check for leaks on the line connections, and if they are good, then check your transmission fluid level after you are finished ...

...the filter was installed backwards. if not you have an air pocket in the line. loosen the filters connection and let the air escape by turning the ignition switch to on for 5 seconds. do not start ...

...p 0441 refers to evaporative emission (EVAP) system --incorrect flow detected ==== causes --- hose connection/s--- intake leak---EVAP canister purge valve replace the purge valve P0441 Evaporative ...

...look at the fuel pump( they loose pump pressure or sees, fuel pump relay, and the fuel pump wiring connector under the rear seat this connector starts to melt sometimes due to bad connection of the ...