...port is in the Engine compartment on the drivers side underneath the air filter compartment. Remove the cap off of the larger diameter line and attach refrigerant can with quick connect
Question about 1993 Lumina
...high pressure side and low pressure side (Return line) and I believe the lines don't even connect to the throttle body on a multi port engine, the lines go to the fuel rails to the injectors. Good ...
...is the passenger side rear brake line, it is rusted through. Have it done by a pro because any connections have to be double flared, then the brakes have to be
...the hater hose hook to the back of the motor when changing the hose because of a leaking or weak connection to the heater core If you have a 3.1L the heater pipe connection on the intake is a
line that leads to your ventilation controls. Connect a length of vacuum hose to either side and BLOW through it. If you can't blow through it, that's the side that goes to the engine since it
...metal line that goes into the car (not the line that goes to the compressor). Where that line has a connection going into the car is where it should be. At times though they can be found in the ...
...filter and Link to connect the line fuel together , make sure no leak . good luck . Hi Misty Percival,this article is showing the instructions of replacing Fuel Pump and Fuel Filter
Question about 1999 Lumina
...connect fittings. Notice: Ensure that the cooler line being installed has a plastic cap on each end that connects to a quick connect fitting. If no plastic cap exists, or the plastic cap is damaged, ...
...with a screwdriver it could be damaged. make sure the flanges are rounded properly and where the connection is
connect via fittings called brake line adapters to the two locations on the bottom left side of your master cylinder. The whole assembly has the brake line adapters, master cylinder, reservoir and the
Usually answered in minutes!
964 Questions
809 Questions
661 Questions
639 Questions
448 Questions