Questions & Answers for: Pontiac connect on line

...Connect the fuel feed line to the filter, then tighten, using a backup wrench to prevent damage, to 20?22 ft. lbs. (27?30 Nm). Carefully lower the vehicle. Connect the negative battery cable and ...

...the mode switch may be the cause, it work on engine vacuum. check all the vacuum lines connect to it. if the vacuum line connects to the defrost actuator came off the you won't have any ...

it does, also check electrical connections are hooked up,heres two diagrams i labeled them, one is for the 2.5 engine and the other for 2.8 engine connect the vaccum line and retry it, hope this helps

...line then tees, one end connects to a connector on the frame. The other end is not connected and I'm unable to determine where it goes. I'm assuming it tore off from either bottoming out or hitting ...

...see if after 2 tanks you can clear the code. If that doesn't help and your evap canister has 2 hose connections, try plugging the hose connection that doesn't go to the tank at the first point of ...

...connect fitting on the inlet line of the filter. The fitting will click in place when the line is properly installed. 3 Bolt the outlet line to the filter with a crescent wrench. Ensure the line is ...

LINE QUICK CONNECT FITTING AT THE POINT WHERE THE FLEXIBLE FUEL FEED HOSE CONNECTS TO THE RIGID METAL LINE LEADING BACK TO THE FUEL TANK. YOU WILL FIND THIS FITTING BEHIND THE ENGINE NEAR THE FIREWALL

...fuel pump not hook up an car want start not sure what your asking for but if the fuel lines aren`t connected then any car won`t start and run.connect the lines to fix it,the fix is not that hard ...

where does middle line of fuel pump connect? 3 lines, feed, return and evaporative, if it is the line with just a hose clamp it will be connected to the fill tube

...to abs Clean the surface of the ABS where the brake lines attach.Some are stamped beside each line connection with LF ,RF, RR, LR, master cyl input front, master cyl input rear if yours is a stand ...