Question about 1998 Explorer
...by step instructions. I have a 99 ford explorer 4x4, v-6 with a 4.0 engine I can not locate the IAT sensor. It is not located on the hose connected to the air filter. Where else could this sensor
...4x4 pickup with 3.0L V6 without pulling the engine? This Seems Pretty Cut & Dry Although I Have Removed Exhaust to Gain Access to Starters on the 3.0L THIS IS Instructions PER> ALLDATA REMOVAL ...
...4x4 actuator may have gone bad and that's located on the front differential. It's common for the clip there to corrode and break and is an easy fix with a new collar pin, at worst it's the diaphragm ...
Question about Crimestopper RS1505DP CoolStart(TM) FM/FM Remote Start System with Two 5-Bu
connect to the power locks etc. Try an Omega DB-GMDLBP module or equivalent. You also have to bypass the Passlock 2 system. If you are not a professional installer I highly recommend you letting a pro
...4x4 actuator may have gone bad and that's located on the front differential. It's common for the clip there to corrode and break and is an easy fix with a new collar pin, at worst it's the diaphragm ...
...4x4 Removal & Installation To Remove: Properly relieve the fuel system pressure. Drain the fuel tank through the filler pipe. Support the fuel tank. Remove or disconnect the following: Negative ...
If you have another type of 4x4 with the extra lever on the floor there are different instructions. I hope you feel my information was very helpful and complete. You can contact us again for more help
...Connect the #1 & #1b poles together to form 4x4' polesConnect the #2 & #2a poles together to form 3x6'8" polesConnect the #3 $ #3a & #4 poles together to form 4x6'5" polesThe ...
...Connect the #1 & #1b poles together to form 4x4' polesConnect the #2 & #2a poles together to form 3x6'8" polesConnect the #3 $ #3a & #4 poles together to form 4x6'5" polesThe ...
Question about 2001 Expedition
...4x4: 1. The vacuum line from the engine intake manifold should be connected to the vacuum reservoir tank. 2. The vacuum line from the vacuum reservoir tank should be connected to the vacuum actuator ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions