.... If you still wish to bridge it: Switch of power. Set mode switch behind amp to "bridge" position. Connect speaker positive to CH1+ve terminal of amp output and connect speaker negative to CH2 +ve ...
...2-connect input wiring to channel(1) input--3-connect speaker across positive outputs terminals-do not use negative terminal when amplifier is operating in bridge mono mode.4-turn down (fully counter ...
2 jbl 115 The protection circuit is most likely shutting down the amp because of heat. When the amp shuts down, does it feel hot? If not, then further investigation into the protection circuit will be
2 Jbl 15 pa loud speakers (non powered) 1 18 Yamaha Sub (non powered) Behringer crossover Behringer 1204fx mixer email: [email protected] There was never anything mentioned about the 18 yamaha sub in
Question about CE1000 2-Channel Amplifier
speakers that have been verified to work perfectly) Both channels do this, before ever rolling gain up, right after connecting to speaker. Any ideas where to start? if ur output power amp is defective
...speakers (Peavey Hisys 2) are connected and the amplifier then switched on, an error code is displayed (LEDs sequenced in red and displayed the code) I cannot remember the code as I switched off ...
...a single box. The mono-stereo-bridge switch must be in bridge position The input signal must be connected only to Channel 1. NOTHING should be connected to Channel 2. The Channel 2 level control ...
...connect 2 Yamaha speaker and a powered JBL sub to the amp... possible?? The red and black connectors are the right (red) and left channels for the speakers, so they should connect. However the sub ...
...CONNECT DIRECTLY TO +12 VOLTS, you will mess up your instrument panel cluster. 6.Yellow (Y) Rear Left (RL) minus (-) speakers return F8 Pins: 1.No Connection 2.No Connection 3.Violet (V) Speed Pulse ...
Question about Ouku 7" Car Dvd Player
...2 sec.no speaker and input during powering. Same thing happen even there is speaker and input connected Check speaker to power bank protection circuit. The circuit is faulty indicating to the power ...
Usually answered in minutes!
62 Questions
68 Questions
33 Questions
21 Questions