Question about X7GNAGAV 17" LCD Monitor
...blue, red, blue, red, blue, red stops and then cycles through it again. Have tried it on different computers and have tried other monitors. They will work, but the Sceptre doesn't work on anything. ...
problems with my volume. One minute it worked the next it quit. I tried turning the volume up that didn't work. I'm not computer wizard, but if I had to guess the problem is inside the monitor. I sure
...displays breifly then goes to blank screen Hi, Whenever I turn on my monitor it displays the computers output briefly (~half a second) before going blank. I have tried the monitor on two other ...
Microtek S1902D monitor I was using the computer and one day the screen just went off. I don't know if there is a problem with the cable of the actual monitor. Please help!! if you have a flashlight..
...signaling "on" to orange within seconds. What gives?? The monitor isn't getting a signal from the computer, which is why the power indicator goes orange. There are two possibilities: 1) The
... First, I purchased this Sceptre X9G Naga-IV back in December of 2005. I hook this monitor up to my computer via the DVI connection. Problem: The problem I am having is that the monitor repeatedly ...
Question about X20G-Naga II 20.1" Flat Panel LCD Monitor
...likely caused by one of two things. Either your monitor has a defect or the video output of your computer is defective. The problem can be isolated by connecting your monitor to another computer ...
...DCL9A flickers on then goes dark. It only flickers on for an instant when first powered on or the computer is booted. Anyone been able to fix this one yet? Hello, It sounds like you have a monitor ...
My monitor screen goes to a grey mode with verticle lines and will not display the computer graphics and data Welcome to Fixya. Vertical/Horizontal lines running on your screen is caused by either ...
Monitor just says no signal - brand new computer. i had the same problem with my PC too .... the problem was with the RAM ... the signal was not passing through it ... . if u got 2 RAM'S try using
Usually answered in minutes!
40 Questions
34 Questions
25 Questions
29 Questions
26 Questions