Question about 1994 LeBaron
...at the same time. Everything else works fine. Checked the fuses and all are okay. Could this be a computer problem? Please help. Thanks, C. Hollis More than a computer problem this looks like a ...
...of the vehicles systems. Most parts stores will perform the scan for free. It will help narrow down any problems/potential problems that the computer has identified. Hope this helped and best
...300M 2004. Engine light goes on and off, mostly on. No apparent problem detected. Have the car's computer scanned. If a light is tripped, it'll set a code in the computer which will not go away ...
Where are the computers located on a 1990 new yorker? Where are the computers located on a 1990 new yorker landau with the 3.3 V6? The engine runs for a couple seconds and then dies. What would be the
...reset but car will still not start check on line,there is a place in georgia that will send u a computer programed to your specific car,there is a computer in front of the car that controls this ...
...problems replaced alternator still no chaqrge. I have been told the computer controls alternator output. but the computer can be bypassed since cannot find a computer replacement. How can I by bypass ...
Question about Computer, Chip, Cruise Control for Chrysler Town and Country
van is not passing emissions inspection mechanic is thinking a computer problem was having no pryor problem with it year 2000 there so many thing that can go wrong with a car not passing emission test
...cap for gas, and the selenoid next to battery but the code still on it does erase on the testing computer but as soon start up comes again..... what really is it...... The code is for a problem ...
...will not shift from low gear Problem started after engine was changed. Reverse and Park are OK. Computer showing "transmission control module" /ground problem. That would mean the trans ...
Question about 2002 PT Cruiser
computer (wherever it is located). Bad ground connections (loose, rusty, etc.) can sometimes cause problems like these. If that doesn't work, use a voltmeter to determine if power is being supplied to
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,198 Questions
1,079 Questions
1,173 Questions