Questions & Answers for: coleman hot water knob

knob on a colmans water heater i have tried and tried to put it back on but it will not turn once i have. so there must be a right and wrong way. please i need it for the easter week Hope you can help

...water tight sealed. Remove the seal and replace fuse. This seems to be a rather common problem, but coleman doesn't give any help on it. There are only aprox 7 screws that hold the case together. One ...

...back towards "OFF". I figured it out after a fresh start in about 5 minutes. hope this help someone if still having a problem with contol knob Coleman Hot Water on Demand ...

...coleman hws same problem on last weekend. Fully charged batteries 6.45volts. New gas bottles. Turn unit on water starts to run gas ignites for one to two seconds and then goes out water will continue ...

...knob decal) locate the circuit board in upper front area. locate fuse on circuit board behind water seal remove and replace fuse and reseal refit circuit board refit housing and decal cross your ...

Just bought a Coleman hot water heater on demand. The knob doesn't turn at all. You are pushing the knob inwards then turning it ?

Coleman on demand hws Spring has become unsprung when replacing fuse How do we reassemble spring in control knob Hi Neil, I think I've sat down for several hours trying to work out how best to fit the

battery ok, & pumps water at normal rate Hi, you may want to check that you are depressing the temperature control knob on the front before turning for the pizzo ignition to work. Hope this helps

...coleman hot water on demand portable water heater (camping), it clicks when I turn the knob but does not run. I have been trying it without putting a propane canister in. Could it be fuse, depleted ...

...knob of my Colemans Hot Water on Demand Model #2300-70 doesn't turn at all. How do I repair this? The control could be defective and will have to be replaced. Its defective you need to replace