Questions & Answers for: coin trap kenmore washer

...found coins in the trap and ran the washer but it is still overflowing. the water level is controlled by a pressure switch. Either something is blocking the sensor hose or the switch is defective. ...

spin cycles. You have a clogged coin trap. Easy to fix. Just take the bottom pannel off and the trap will be right before your eyes. Clean it out and should work fine. Good luck and save yourself $120

...have a something slowing down the drain.. you can remove the bottom panel and clean out coin trap... if there is nothing then you may have another problem... but this is the most common

Clothing and coins continually become trapped between between the inner and outer tubs. I've had to replace the drain pump once due to a coin becoming lodged in the pump impeller. I've had 2 pieces of

...trap. There is a coin catcher on the pump. The design of the wash action on a front loader is such there is less lint than on standard machines. One of the bennies of the design. Eric There is a lint ...

laundry, the washing machine stopped. So you have water in the bottom at the end of a cycle. Clean out you drain pump's coin trap, and stop putting clothes into the washer without clearing the pockets

...kenmore 417-43042200 remove the lower toe kick panel below the door and remove the clean out trap,its a 2 to 3 inch round plug and it unscrews and it is probably full of debris ...

...coin trap hose , I'm finding it very hard to find info for this washer ,thanks Assuming you mean the hose which goes into the pump, it would be part number 8181732, Available from Sears ...

...coin trap Replacing shock absorbers and coin trap, front load washer. I have Eco Care 417.43042200. It started putting a lot of water on the floor, and I eventually found a hole in the coin trap. I ...

coin trap. Turn the trap handle counter clockwise to unlock and remove. Get your bucket under the opening as much water will come out. Check the coin trap for debris, coins, socks etc. If you find the