...at fault. The best way to determine the problem is to have a scanner/computer to read check engine
...esc wire on a vortec. the distributor is set to zero degrees. if the check engine light stays on then adjust the distributor, clear the code, and try again. once the light will stay off it should be ...
esc code showedxd upon dash board of card and esc code showed up on dash board. It isnt real serious. could easily just be a loose wire or connection. It is very repairable. I dont know the techs ...
...ESC, Service Traction, and reduced engine power. i put a headunit in and was messing with the fuses and it started doing this. what did i do?? That light means that the computer control module has ...
Question about 2009 Malibu
at on my 95 chevy s10 blazer 4.3 vortec im geting gas and spark it well run for a seck. thats it my codes are pulling the (esc) spark control module where is it at on my 95 chevy s10 blazer 4.3 vortec
...ESC. Anyone have any ideas on this? I am going to go get the error code checked tonight, but any ideas off the top of anyones head on what the possible soultion would be? I would much appreciate that ...
Code 43 is electronic spark control. ESC module is not receiving a knock signal from knock sensor. Check knock sensor/wiring, check ESC (parts store can check for you). That's what the book says to do
ESC. YOU NEED GOOD SCANNER TO FIND THE CODE.THE ONE WILL SCAN BUMPER TO BUMPER. ESC WORK WITH ABS STEERING ENGINE TRANSMISSION AND SUSPENSION.THE PROBLEM CAN BE ANYWHERE. POST THE CODE AND I WILL GIVE
Why do esc, traction, and engine lights turn on? Check the engine codes first. Some codes will shut down the ESC and traction. Then Traction codes will shut down ESC. With out codes we just guess.
...Control No matter which it is you should have the vehicle checked for DTC'S - diagnostic trouble codes DTC Database OBD II Trouble ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions