Question about 1996 Tacoma
96 tacoma failed inspection because O2 sensor was ''missing bolt'' My 96 tacoma just failed a state safety inspection because the O2 sensor was ''missing bolt,'' as it states on the report. I replaced
I have a 99 tacoma with no power to fuel pump,fuses are good, power to relay and have swapped relays, but I don't have any power to the fuel pump. Is there some type of inertia switch? Look to see if ...
1997 toyota tacoma has high co emissions what to check to lower this reading Have the 02 sensors checked. high co is caused by an overly rich mixture. this is affected by many things such as: needs ...
...pop the hood. locate where the light you need to replace is located. its in a housing, turn it counterclockwise to free the housing and pull the bulb and housing from the headlight. the old bulb ...
i got a p0141 code on my 2001 tacoma v6 what is the problem p0141 indicates that the heater in the upstream (#1) oxygen sensor has failed. It will take longer for the O2 sensor to heat up, taking ...
96 TOYOTA TACOMA 2.7 ...HAVE REPALCED THERMOSTAT 3 DIFFERNT TIMES CHECKED HOSES KEEPS KICKING CODE INSUFICENET COOLANT TEMPETURE LOWER LOOP... WATER PUMP DOESN'T LEAK OR MAKE NOISE BUT COOLANT DOESN'T
fingertips and lift on front edge of hood. Then use lever located in middle of the grill to release completely. Then, most important, lubricate all rubber moldings along hood that come in contact with
...idle car is parked, so is 100% safe tests. (not moving) so it surges at idle. questions.? 1: hot or cold or both.? 2: low extreme RPM and high at idle. 400 to 800 RPM? surge. 1000 to 2000. what? ...
...CO, or NOX? or ? based on your numbers is HC hydrocarbons or in barstool, its raw gasoline leaving rear of car. unburned fuel.. 572 ppm is way too high 12-19 is normal id say the CAT is bad. but can ...
Usually answered in minutes!
352 Questions
307 Questions
394 Questions
295 Questions
304 Questions