Questions & Answers for: cmp circuit

...circuit CMP Sensor 5v supply circuit is open or shorted to ground or to battery voltage CMP Sensor ground circuit is open CMP Sensor is damaged or has failed CKP Sensor is damaged or has failed PCM ...

...circuit CMP Sensor 5v supply circuit is open or shorted to ground or to battery voltage CMP Sensor ground circuit is open CMP Sensor is damaged or has failed CKP Sensor is damaged or has failed PCM ...

...CMP Sensor signal circuit is open, shorted to ground or battery. voltage or 5v supply.CMP Sensor ground circuit is open.PCM has failed.Trouble Code: P0016Crankshaft/Camshaft Timing ...

...sensor ground circuit is open.CMP (Hall) sensor power circuit is open (check fuse in the I/P).CMP (Hall) sensor is damaged or has failed.PCM has failed.The other code is not listed in this

...CMP) Sensor Circuit P0340 ?€¢ The ECM detects that the starter is commanded on and the engine has been cranking for more than 4 seconds without a CMP sensor pulse. OR ?€¢ The ECM detects that the ...

...Circuit/System Testing. Ignition OFF, disconnect the CMP actuator solenoid harness connector at the CMP actuator solenoid. Test for less than 5 ohms between the low reference circuit terminal 2 and ...

...CMP Sensor Circuit DTC P0365: Exhaust Camshaft Position (CMP) Sensor Circuit DTC P0341: Intake Camshaft Position (CMP) Sensor Performance DTC P0366: Exhaust Camshaft Position (CMP) Sensor Performance ...

...CMP) Sensor Circuit Low Voltage Bank 1 DTC P0343: Intake Camshaft Position (CMP) Sensor Circuit High Voltage Bank 1 DTC P0346: Intake Camshaft Position (CMP) Sensor Performance Bank 2 DTC P0347: ...

...CMP Sensor Circuit DTC P0341: Intake Camshaft Position (CMP) Sensor Performance DTC P0365: Exhaust Camshaft Position (CMP) Sensor Circuit DTC P0366: Exhaust Camshaft Position (CMP) Sensor Performance ...

...CMP circuit open CMP circuit short to GND CMP circuit short to voltage SIG RTN open (VR sensor) CMP GND open (Hall-effect sensor) CMP circuit short to CMP2 circuit (if equipped) CMP incorrectly ...