Questions & Answers for: clutch won 39 release pressure

Ad

Question about Washing Machines

1 Answer

...won't empty water 3. The water has pumped out properly, but a blockage of gunge inside the pressure chamber bottle is trapping the air that's operating the door lock (if a pneumatic lock is ...

Ad

Question about Kenmore Washing Machines

1 Answer

...won't agitate or spin. It goes through all the cycles but the tub doesn't move if its a direct drive , make sure the brake is releasing for starters, If the spin basket has difficulty getting ...

Ad

Question about Washing Machines

2 Answers

won't spin then the switch is most likely bad, you can however twist the wires together ont eh switch to see if it is the problem but you will be left without the safet device to keep someone from

Question about 1994 MX-3

1 Answer

...won't go! can be pushed easily. when clutch is depressed, can run through gears with no grind, but when try to release clutch to move...nothing! It sounds like either the clutch plate or pressure ...

Question about 1994 MX-3

1 Answer

Clutch quit working while I was driving. It goes completely to the floor & now won't go into gear. What does that sound like happened ? Pls help I'm a women w/ no family alive Check around

...won't move but the motor runs and the clutch is new and the slave cylinder also it's been bled. Will shift but wont go into any gear including reverse. Any ideas? Have you just replaced the ...

Question about 1998 Civic

1 Answer

clutch won't release clutch won't release the machine needs to be serviced by a sewing machine repair shop

is making noise, it is good practice to do the whole clutch replacement while the transmission is removed.  If your budget won't allow that, at least check the clutch friction plates for wear

Question about 1996 VS 1400 Intruder

1 Answer

clutch won't release clutch won't release Start with inspecting the clutch handle for any obstructions or rust.Lubricate the clutch cable at the handle.Follow the cable down and look for ...

...clutch pedal into the master is bent or binding up and won't travel into the master.  You could check if master operates easily by taking line off at the slave cylinder (or if not able ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Brad Brown

Level 3 Expert

18108 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...