clutch drum feels ''loose'' but will not slide off the engine shaft. I have applied moderate force but something seems to be holding it on. Is there some trick or is it stuck due to wear of the inside
...gearing appears to be stuck as, as soon as the machine bursts into life the gearing is engaged abd th wire spins if your machine has a clutch the idle may be too high causing it to engage all the ...
Question about 14" Grass Hog Xp Trimmer/Edger
...head to see if there is something loose there. Good luck...Lee almost always, the clutch "fingers" are stuck because of rust / yard debris... dissasemble the housing and lean the clucth , ...
Question about 14" Grass Hog Xp Trimmer/Edger
the arrow. Most of them come off counter-clockwise. If its stuck, spray some PB Blaster or Liquid Wrench on it at the threaded shaft area. Don't get the oil ln the clutch faces. Let soak and try later
...clutch is stuck, it's possible to clean and lubricate it, but if it has any broken or bent parts, it must be replaced. Reassembly of the clutch and drive shaft assembly is the reverse of
Question about 27cc 2 Cycle Crank Straight Shaft Weedwacker Gas Trimmer ()
loosen the screw in the end of the shaft. After it's loose, the clutch drum will come right off. Unfortunately, I am stuck now trying to get the rest of the clutch assembly off without damaging it
Question about 27cc 2 Cycle Crank Straight Shaft Weedwacker Gas Trimmer ()
...stuck, or caught up in anything, on dismantiling, as you say, motor running, no drive. It was get a new one, or bust, so I put a small tack of weld on gear/drive and reduced fuse rating to 8 amps, ...
Question about 27cc 2 Cycle Crank Straight Shaft Weedwacker Gas Trimmer ()
hi there, my gardener got the cable stuck in the electric line trimmer head and since then the line just pulls out. what could be wrong? line has wrapped around clutch and needs to be removed
Question about 27cc 2 Cycle Crank Straight Shaft Weedwacker Gas Trimmer ()
...clutch stuck engaged Is the shaft seated into the engine all the way and is the gearbox (where the weedeater head attaches) shoved onto the shaft far enough? There’s a set-screw holding the gearbox ...
Question about 27cc 2 Cycle Crank Straight Shaft Weedwacker Gas Trimmer ()
...no prob but as soon as i go to trim about 3mm of wood the bar gets stuck and i have to clear the branch, the trimmer seems to be low in power binding / chain to tight ===clutch worn --chain not ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions