Questions & Answers for: clutch plate faulty

...clutch plate facings may be 'stuck' to the flywheel and pressure plate surface. To check/clear this problem:- (with the engine not running!) hold clutch pedal down - then from under vehicle, find an ...

Ad

clutch disc, 3. release lever and bearing not assembled properly, 4. faulty pressure plate., 5. pressure plate-to-flywheel bolts loose. Another thing would be to check the fluid to make sure you don't

Ad

...that it opens with a little less depression of the pedal? YOU COULD HAVE WORN CLUTCH PLATE AND PRESSURE PLATE.YOU COULD HAVE FAULTY RELEASE CYLINDER OR RELEASE BEARING. FAULTY GEARSHIFT CONTROL

Question about 2003 X-Type

1 Answer

...plate, clutch plate and thrust bearing) not hydraulic? (clutch master and slave). Sounds like your clutch is slipping. Worn clutch plate would be the most obvious cause of the problem but it could be ...

Question about 2006 9-3 Aero

1 Answer

...at a stop. Scynchro rings and dog plates have gone faulty and need to be replaced,cause the clutch or pressure plate whent faulty and was driven this way then the Scychro rings and dog plates

Question about 2006 9-3 Aero

1 Answer

. If all is ok then the clutch pressure plate is weak allowing the clutch plate to slip under load. In that case the fix is to remove the gear box and replace the clutch assembly with a new clutch kit

...clutch plate covered with grease /oil ---OR--- faulty engine mounts. pedal to the floor is a problem in the hydraulics or a cable failure. A cable failed and jammed will also cause a slipping clutch ...

...clutch plate but this always results in a poor performing clutch Installing a clutch kit without first removing the protective coating on the pressure plate is a problem as well Incorrect tightening ...

...fitted clutch, faulty clutch or oil on clutch plate causing judder The flywheel needs skimming/resurfacing .you have a shudder because if a rough surface from the fly wheel on a new clutch

...clutch pressure plate has become weak. When you press the clutch pedal the release/throwout bearing presses against the centre of the clutch pressure plate. This causes the metal 'fingers' -the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...