...OIL AND DUNK THE FILTER IN THIS USE GLOVES THOUGH ITS VERY STICKY STUFF THEN CHANGE THE SPARKY JUST UNSCREW AND PUT BACK IN THEN JUST START IT UP WITH THE REAR WHEEL IN THE AIR AND PUT IT IN GEAR AND ...
oil, ??? The bike runs fine at idle, power band response is fine, no exhaust ''pop'', just worried about a cylinder wall or head problem in the making. Leak back / compression test even gave very good
...are pretty robust so if it's not slipping (worn out) then it's likely an issue with the oil used. your clutch basket is prolly grooved. take the clutch cover off and check the fingers on the
...oil level sight glass as such on the '08 RMZ450. About halfway up the clutch cover is a allen key head bolt. Run the bike until it's warm and then turn it off. Wait a couple of minutes and then take ...
...Wait for a couple of minutes and then about halfway up the clutch cover is a level bolt. Remove the bolt and if the level is correct there should be a slight dribble of oil coming out the bolt
...off. Wait a couple of minutes and then halfway up the clutch cover is a level bolt. Remove the bolt and if the oil level is correct there should be a slight dribble of oil coming out of the bolt
...and top end then. Running synthetic 10w- 40 and a rekluse z start pro clutch. the head may need machining , the other gaskets shouldnt leak if installed correctly. nothing to do with oil not ...
...oil be in the non clutch side cover of the motor on a 2007 rmz 450 Hi Justin, for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any ...
Usually answered in minutes!
83 Questions
0 Questions
