Questions & Answers for: Honda CR 125 R clutch oil

...power from the engine to the transmission. drain the oil and remove the side cover to access the clutch basket. you'll need a new side cover gasket as well as a new clutch pack (friction &

...cable when the lever is all the way out. This is so the clutch won't drag. If your adjustment seems good, and you have changed your tranmission oil, you might have an issue with the clutch worn

...are there is to much gear oil in the gear box causing it to be spat out of breather just drain gear oil and refill with correct amount which is usually on the engine casing clutch side hope this ...

...a 2003 cr125 take ? about a full court of oil there is a 10mm screw on the right side of the motor next to the clutch covor when oil starts coming out of there you stop poaring and screw in the ...

...use either an 80 wt (weight) motorcycle gear oil or for the racers edge a 70 wt motorcycle gear oil to increase the life of the aluminum plates in the clutch and help preserve the transmission

How much transmission oil do you need to put in a 2004 CR125R? You should see a stamp near the clutch cover. (650ml) Or 650 cc's

...to get it sealed. 9) Fill with amount of oil specified on the side of the crankcase. Make sure you use 'cycle oil, with MA rating. Auto oils will allow the clutch to slip, and make it burnout

oil inside the clutch plate?? NO, they use a dry clutch, sometimes referred to a Dry Sump Clutch. The friction of the discs is what makes the clutch work, if there was oil in there the clutch would no

oil makeing the plates to not relase correct could you help me out thanks Hi, sounds like you may have too much free play on your lever, when you pull the clutch it is not disengaging all the way, try

...for the gear box, but make sure it is motorcycle oil or the clutch might slip. For the engine to mix with the fuel choose any of the two stroke motorcycle oils, the mixing ratios are often on the ...