clutch won't engage--cannot shift when clutch is depressed, shifter stick with not change gears...replace the clutch? hydraulic clutch needs servicing or needs bleeding like a brake system wont work ...
...bleeder screw cover from the clutch slave cylinder (7A508) and attach a hose to the bleeder screw. Place the other end of the hose in a container. Slowly pump the clutch pedal (7519) several times. ...
left side brake caliper wont close. no pressure No pressure or stuck piston in the caliper? When you bleed the line are you getting fresh fluid and plenty of it? I think you might just have a bit of ...
took out thermostat car is still heating up what is wrong probaly have air in the system. look for bleeder screws
I replaced my front brake pads and one caliper and rotor, when i went to test the brakes, the car would not roll forward...they feel like they are seized...what can i do to fix this? Open the bleeder ...
...out from a stop on level ground, I have to tach the thing up to about 3500rpm then dump the clutch to take off. If I don't the thing moves like a slug untill it hits 3000 rpm. I was told it ...
How do you bleed the brakes for a 1997 mercury tracer? on the caliper thare is a bleeder screw. you will need to open and close it.have someone step on the brake pedal 10 times and hold it down.with ...
how do you bleed the brakes Make sure resevoir is full then start from the farthest from the master cylinder n work toward master and pump 3 times while someone opens the bleeder do not compress all ...
engine overheating after driving for like 20 miles The engine seems to be running fine until about 15 miles it progressively get hotter until just after 20 miles where it gets tooo close to te red ...
1993 Mercury Tracer coolant bleeder Need to know where the coolant bleeder is on 1993 Mercury Tracer. PIC would be appreciated. Also the procedure on how to bleed it... Thanks. Never seen this or even
Usually answered in minutes!
157 Questions
123 Questions
136 Questions
106 Questions
78 Questions
