Questions & Answers for: close hood

...hood to close without the rod interfering with the closing of your hood.This can either be obtained at your dealer or salvage yard. Then you will need a 4or 5 foot poll in order to prop your hood.So ...

...hood to close completely. The only thing holding it closed it the safety latch. Try "resetting" the lock. With the hood open-lube the lock good with wd-40 or similar and go pull the hood latch handle ...

...hood close out filler retainers. Remove the hood close out filler panel. Remove the upper radiator mount bolts. Remove the upper two hood latch support bolts. Remove the two lower hood latch support ...

...close hood and lift up on hood to see if it stays closed. if not, check inside car to see if latch(that you pull) is in the correct position. you can tell when hood is closed that there will be some ...

...close my hood it would only lock into the first latch that you can manually release, not the one controlled by the hood release inside my car. When I went into my car the hood release did not go back ...

...the hood straight, tighten a bolt on either side then close the hood. if it closes and opens while being evenly gapped on both sides tighten all four bolts. then replace the washer hose and

Chevy Prizm Hood Is Stuck Closed The hood on my 1999 Chevy Prizm is stuck closed. Pulling on the hood release latch inside the car does nothing. How can I manually open the hood? try pushing down on ...

...hood latch Close the latch with the hood open to make sure it works. If it does make sure the hood release handle,is in all the way and adjust the latch assembly have some one operate the handle as ...

...hood. To close the hood: Before closing the hood, be sure all filler caps are on properly. Then, bring the hood from full open to within 152 mm (6 in) of the closed position. Pause, then push the ...

Says hood is open but it’s closed? The hood-switch is usually a spring-loaded normally-closed type, meaning that it is closed, ie sensor wire grounded to bodywork, when nothing is pressing it. Closing