Questions & Answers for: Bissell clogging

my vacuum get cloged my bisslle 3596 clean view deluxe alway gets a clog of fur and dirt in the hose. my filters are clean and i on clog the problem shoud i take the vaccum apart? i haved to unclog at

Clogged Bissell After debris clears the brush part, it gets clogged at the point of entrance into the machine, barely anything makes it through the filter and into the canister. Clogs immediately ...

its blowing air out the air filter.no suction high r.p.m.'s Check the dirt inlet down by the brush roll for a clog. Also check the hose for a clog. Usually a clog is what causes this type of problem.

no water/soap will come out ? tanks are not sealed into receivers ? faulty auto load receiver ? pinched/clogged line ? defective component allowing air into system ? pump not mounted so it can move ...

Bissell Lift-Off Revolution keeps clogging Every time I use my vacuumn(it is the Turbo model) the debris gets stuck before it makes it to the canister bucket where you would take off to empty the vac.

clogged hose... I have a clog in my hose, probably a sock, I have pushed it through to the hard plastic handle end of the hose, help! can the plastic handle wand be disconnected from the hose to ...

WHEN WE USE THE HOSE ON THE VACUUM DUST AND PET HAIR COME OUT OF THE HOLE HELP A clogged hose is the most likely problem. Disconnect hose at both ends and try dropping a coin through it. If clogged, ...

I have the 7350 prodry carpet cleaner and it while cleaning a room today it completely shut off with no rhyme or reason. It has a build in clog protector. Once the machine starts to overheat due to a ...

bissell pet CARPET CLEANER WATER DOES NOT COME OUT Replace the belt or belts depending on your model. The heater may be clogged. The jets could be clogged. The pump could be clogged or needs replaced.

bissell proheat 2x water will not come out at head with rollers only used 2 times If it sprays at the hand tool but not at the floor check the water jets under the machine by the brush roll to see if ...