Questions & Answers for: clock hands

...hands of the clock if required. Some battery-operated clock movements are sealed inside the clock case with a back panel that is screwed in place. To gain access to the hand set knob, remove the back ...

The second hand on our LaCrosse atomic clock has stopped moving but the clock continues to keep perfect time. How do we get the second hand turning again? The manual for one of their clocks says the ...

...hands after clock stopped.Now clock is out of sequence. It is a mantal clock- 4 decretive columns on front. The hour hand is a friction fit, so you can probably just remove the clip or cotter holding ...

...get the hands back on clock They are a spoon and knife This article will walk you through the process. ...

...clock can't get hands to go back on clock..long and short hand no second hand. dropped clock back fell off and front hands fell off.. hands are knife and spoon put the smallest one on first and the ...

clock with large hands...no second hand only minute and hour. The small black wheel on the back just goes round and round without moving the hands on the front. The time setting mechanism is defective

...hands. The clock was a gift in 1943. Wanting to know is there anywhere that we can source replacements hands either second hand or new? Clock hands can be very tough to find as I am sure you know. I ...

clock, remove the hands and then replace them at 3 o'clock. Larger clocks have the hands secured with a nut that can be unscrewed. Smaller clocks have hands that are pressed-on. To remove these, place

...clock hands are friction held. DO NOT BEND YOUR HOUR HAND, loosen the shaft if it will not turn freely. Once you have synchronized the hour hand with the hourly chime, adjust the minute hand to set ...

...hands, on of which has fallen off, without damaging the clock works inside? Unless the clock is an older traditional 'clockwork' mechanism most clocks have a sealed unit as a mechanism so you ...