...of the buttons on the keypad will not work, I have unpluged the unit . It comes back on I reset the clock & everthing is fine , but about 20 minutes later the process starts again. I have found if I ...
...and then comes back up as if someone unplugged it for a couple of seconds and you can set the clock and start again, then you have a magnetron that is leaky. Once you listen to that and check ...
...I would suggest is a hard reset. Unplug the unit for a minute or so. Then plug it back in, set the clock and try again. If that doesn't work, leave it unplugged for about 5 minutes. If it still
...I would suggest is a hard reset. Unplug the unit for a minute or so. Then plug it back in, set the clock and try again. If that doesn't work, leave it unplugged for about 5 minutes. Then try it
...Hope this helps all button solutions failed. Unpluged for a few seconds. pluged in and had to reset clock. lock ...
...If that fails, you probably have a short in the key pad or the wiring between the keypad and the clock. This will need to be checked and probably replaced. The wiring gets checked for broken ...
Question about SMH9151 Microwave Oven
Without any known event, the microwave clocked no longer keeps time and the microwave does not heat up food. The timer works and the tray rotates, but no heating. You have 2 systems inside your ...
Question about SMH9151 Microwave Oven
...fail due to overloading. Also, the control panel can go bad or become unplugged from slamming the door, etc. If you do have lights, clock etc., then a faulty door latch will prevent operation of the ...
Usually answered in minutes!
106 Questions
68 Questions
72 Questions
52 Questions
48 Questions