Questions & Answers for: Subaru Impreza over clock fail

Question about 1998 Impreza

1 Answer

...stays there. The tempeture gauge doesn't move at all. Just the rev counter works. Does the whole clock need to be replaced or would a fuse or something just be gone in it? Yeah, i had this problem ...

Ad

...new stereo installed and working in attempting to install a new stereo receiver, the dashlights, clock, dome light became disabled - and the stereo will not power up - and I suspect the airbag is ...

Ad

Question about 2001 Impreza

3 Answers

dash clock not working Trace the fuse in the car. It has gone bad. You only need to replace it. Please rate this. It is probably not the fuse, but the clock is most likely on the fritz. This is a ...

the dash board lights are not working and the the dash board lights are not working and the front and rear fog lights as well.check the fuse and it was blown,replace it but it still blew,and it ...

Question about 2000 Impreza

1 Answer

Failing rear wheel bearings I've replaced the both rear bearings on the Left side twice and the Right side three times. I'm wondering what is causing the bearings to fail so fast and not last at all? ...

Question about 1995 Impreza

1 Answer

...ribbon circuit contact under the steering wheel having a broken filament, the part is known as a clock spring contact, u will need to properly disarm the airbag and remove the steering wheel to ...

my scooby 2l turbo only has 110 mph on clock,is it i have just bought a 1994 impreza wrx 2 litre turbo,its a *** import and only has 110 mph on the clock.is it restricted and if so how much will it ...

...fail to start. Engine cranks over but does not fire. It seems to occur between 5 minutes and 30 minutes after a trip. I have replaced plugs, wires, coil, thermo sensor. It starts almost every morning ...

Question about 1998 Impreza

2 Answers

...link unfortunately..... Has the clutch been recently replaced ????? How many miles are on the clock ??? What kind of noise are you hearing ??? Don't know what you mean by "cut"? If you mean

...fine on the way back sometimes when i put my foot down hard it seems to hold back and the boost clock was reading 1.5 bar which it has never done but if u ease it down and dont let it go passed 1 ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...