dim the clock display. The resistor heats up which causes the solder joint to become fragile and break. Take out the clock (unclip the bezel, then a couple of screws.). The resistor is quite large and
...dim, but didn't think much of it at the time. I got a few miles down the road when the radio shut off and I lost power steering and a few other systems. I pulled over and turned the car off. When I ...
...dim, but didn't think much of it at the time. I got a few miles down the road when the radio shut off and I lost power steering and a few other systems. I pulled over and turned the car off. When I ...
dim the clock display. The resistor heats up which causes the solder joint to become fragile and break. Take out the clock (unclip the bezel, then a couple of screws.). The resistor is quite large and
...clock works intermitently. Sometimes the numerals are very dim and other times are not there.Could this be a low voltage/bad grounding problem? Sounds like your clock is dying. This is typically an ...
dim switch. Good luck and have a great day. If the clock is a standalone in the dashboard, then there is a problem with it. You may have to replace it with a new one. The clocks in these older Subaru&
Usually answered in minutes!
447 Questions
411 Questions
381 Questions
354 Questions
317 Questions