Questions & Answers for: Yamaha how to clean well pipe Refrigerators

Ad

Question about 2001 TW 125

2 Answers

...when I start to push back the choke. It also stops when I pull the throttle Things I`ve tried: -cleaning each part of the carburator -checking the fuel level in float chamber -cleaning the air ...

Ad

Question about 2001 TW 125

1 Answer

...pipe, repacked it, changed plug, bike started and still backfired badly, then would not start and run unless I kept the choke out, as soon as I put choke in, it stalled. I took carb off cleaned it, ...

Ad

...Clean out any build up with a screw driver, preferably from the exhaust side. Decarbon the head and the top of the piston and reassemble top end and exhaust pipe. If still no joy, the crank seals, ...

choke You need to disassemble and clean your carburetor. Make sure the jets and carb body passageways are clean and clear. Unburned fuel from running the cycle on choke is burning in your exhaust pipe

Question about 2002 TT-R 250

1 Answer

...cud I locate replacements as cheaply as possible?? There are a lot of second hand and used but clean pipes offered for sale on ebay. Worth a try? Hope this

Question about 2002 TT-R 250

1 Answer

...it was backfiring on deceleration. it blew a 5 inch hole in the header pipe. i purchased a new one, cleaned the air filter, changed the oil and put a new spark plug in it. now it is still backfiring ...

...pipe back to a carb to confirm this guess. If I'm right, you probably have a problem with the nedle valve in a carb sticking. I would suggest: Remove carb, remove float chamber, take the pin out ...

Question about 1989 TZR 250

1 Answer

yzf 600 cylinders 2 3 not firing 2 and 3 center cyclinders not firing cleaned carbs replaced the coil and installed new plugs but pipes still cold until i held my hand over the mouth of those carbs ...

.any thoughts would be greatly appreciated weak mixture ! all 4 red ? carb version , or injection ? clean fuel system ? was it running ok b4

Question about 2012 YFZ 450

1 Answer

...it off on a clean, lint-free rag. ... Insert the stick back into the pipe. ... Pull the dipstick out again and look at the film of oil on the end of the stick. ... Put the dipstick back into the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...