Questions & Answers for: Suzuki T 350 how to clean well pipe

...for spark on each of the new plugs then install the plugs. Remove the carbs , dissemble it and clean the varnish out. Remove the petcock, ( gas valve ),water trap and clean it out. Next let one ...

Ad

Question about 1971 T 350

1 Answer

my 1971 ts250 wont idle, it runs fine at higher RPM's but i have to choke it to start it and rev it to keep it running. ive cleaned the carb 3 times since spring and cant figure it out. i fixed the ...

Ad

Question about 1972 T 350

1 Answer

...and out of the ignition switch. Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the ...

1994 suzuki quadrunner 250 is having a problem running i bought the four wheeler about two months ago and it was'nt running right. we thought it was the fuel pump so i took it off cleaned it and tied ...

...carb on the Suzuki LT50 quad i need to tune the carb, my sister Boys put water in the tank. i have cleaned it all out and unblocked the main jet which made it run heaps better but i can't seem to ...

i have a suzuki 400 atv eiger 2003 i would like to change the oil and filter,can you help me. actually the write up from ollie reese is not correct and is demontrated on a kawasaki. Though kaw is ...

...ts 125 that starts and idles fine but bogs down when i give it gas and try to ride any ideas? Clean your carb and replace your spark plug that should fix the problem. Needlt jet clogged. Clean ...

Question about 1971 T 350

1 Answer

...be appreciated Stef. Briggs has used several different carbs over the years. It sounds like time to clean the interior of the carb. If your carb has a float bowl, remove the bowl and use spray carb ...

Question about 1971 T 350

1 Answer

can you tell me where the spark plugs are on my quadzilla 250e lost booklet and am new to quads many thanks Observe the bikes engine where the only wiring connection is attached. Spark plugs are ...

...but has corrosion at the connection. It is a good idea to undo the connections for inspection and clean them up with a small brass brush and some contact cleaning type

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...