Questions & Answers for: Suzuki GSF 400 Bandit how to clean well pipe

...have a 1991 Suzuki 400 bandit. It was running fine but stopped, seemingly getting starved of fuel. cleaned fuel tap and it went again great. but now it won't idle. It feels like it is hunting for ...

...it starts up and rides finee possibly **** in your tank which has blocked your jets in the carb, clean out tank and fit an in-line fuel filter and clean carbs, imports often did this due to rust ...

'95 400V 16v. Melted fuse gave lights etc, new one no power '95 400V 16v. Starts 1st go in 2 secs. Started feeling sluggish and suffocated. Cleaned carbs, tank, pipes, oiled choke, etc.Starter ...

Hello! I have a suzuki gsf 400 bandit 1992, and not much is at idle. It is very difficult tureaza but at idle, and when you get there does not really sit at idle. have you cleaned and syncronized your

...is hard to start. This could be almost anything, probably minor. Good premium unleaded fuel, fresh/clean and gapped plugs, fuel filters clean,. Carbies clean and jets good, correct float levels, no ...

petrol in airbox sounds like you have a stuck open float in one of your carbs,try cleaning the float needle and its seat,inspect needle while disassembled if the needle has a ring on its tip,replace ...

...clean and in sync, Bike idles perfectly, but when any throttle is given, the engine is restricted to 2k rpms. Stock jetting, and a slip on pipe. i think the fuel filter inside the tank is dirty, or ...

...look at them closely . Is it soaked with gas ? or is it dry as a bone ? if it is soaked with gas, clean it up and dry it off, now check your gap it should be alright but just check it anyways if

i have a 1991 suzuki bandit 400cc, i cant get fuel down to the carbs, i have had the tank cleaned, installed a new petcock and had the carbs cleaned, also put all new fuel lines on it, still n fuel, ...

...trying to open the throttle this also makes the engine cut out instantly. have removed the carb and cleaned jets etc, replaced fuel with clean fuel but did not solve the problem.any ideas.? new plugs ...