Questions & Answers for: Stihl how to clean well pipe Motorcycles

...pipe.Look from the chain side of the saw. Best to take off the Starter (recoil) Cover. This is when you realise that you haven't cleaned your chainsaw properly ,for a very long time... ! Look at the ...

...clean the oil pipe to the tank by removing the oil cap and blowing through with an air line. If the oil in the tank contains alot of dirt, empty/clean and replace. The filter on the oil is an open ...

...clean you can then se the pipe and filter. . The pipe disconnects from the carb and goes through a gromet on top of the tank. If you remove the gromet with the two pipes going into the fuel tank the ...

...clean, and I also needed to replace the primer bulb so I took both out of the saw. Now it is time to put them back in I don't know where the pipes go and I can't find any diagrams as to where each ...

...pipe and pick-up body back into the oil tank. Make sure both the inlet and outlet of the oil pump are clean of debris and replace it along with the clutch and drum. Also blow out the feed groove to ...

carb with sonic cleaner. It still wont run full speed. Most often on this model, the 'spark arrestor' screen is plugged. it is located on the end of the removable exhaust pipe. Clean with a wire brush

...pipe or bushing that will allow the pump to be pulled up and out of the housing. ** be very careful to remember the alignment of the inlet slot on the pump position to the gear case. The slot on the ...