Questions & Answers for: Mazda 3 how to clean well pipe

My mazda 3 wont accelerate when you push the gas pedal car will not accelerate when pushing the gas pedal Depending on whether or not it stalls when you put it into gear it may be the clutch slipping.

2000 rpm idling with clutch depressed My 2004 mazda3 I 2.0 idle goes up to 2000 rpm everytime i hit the clutch. it started doing this after i cleaned out the throttle body? i dont know how to fix it, ...

both: flush and filter. The filter and the pan hold the real contaminants, so those get changed and cleaned...but then you're left with a giant amount of fluids in the system. Torque converter, piping

...was the last service were the brakes looked at ? if no get them looked at make sure the discs are clean, and the edge is not got a lip

my mazda 3 diesel is surging when I first start her. What could be the problem? This happens when I first start her in the morning and then she is fine after a about 5 miles. Then again ant the end of

2012 mazda 3 key fob trunk release does not work Key fob trunk release Probably dirty inside, take it apart, clean all parts and put it together.

...quick to replace the washer pump. The problem is often just a clog in the sprayer heads. You can clean out the sprayer holes with a needle, some have two holes, so look closely. Hope this

I'd like to replace the TCM. Where is it located and is it easy to remove? Clean corrosion if any found,Step 1 Take out your battery, Step 2 take out your battery box and its holder the whole thing, ...

How to Clean a 2008 Mazda 3 Gearshift? Soap and water.

Hi am Juan I have a 2010 Mazda 3 2.0L have problem with the steering I replace the power steering pump still hard steering help pls Maybe the power oil container need to be changed ..and check the ...