Questions & Answers for: Ford how to clean well pipe

Ad

Question about 1996 Crown Victoria

1 Answer

...filler pipe, screw from filler pipe retainer, slide into the tank until it can be rotated and pulled out through the fender. lube the tank grommet with clean oil and reverse the removal for

Ad

...and pipes connected Take pipe of washer pump,see if if it pumps If not remove pump,check and clean filter ,if this model does not have fiiter,and you can hear pump and it is not pumping,replace

Ad

...3rd gear, most noticeable when overtaking which can be a bit hairy sometimes..EGR valve was off and cleaned etc...drove mighty straight after cleaning it...next morning back to square one..no ...

...clean brake fluid comes out of the pipe tighten the pipe again and pump the brakes. Then step on the brake pedal and hold it in, while the brake pedal is depressed open the bleeding nipple and close ...

Question about 1996 Ranger SuperCab

1 Answer

...it out of fuel hav spark installed new fuel pump new plugs You have picked up the sediment from the bottom of the tank causing a blockage in the pickup pipe in the tank.Remove and clean out the

...to unseize it from the pipe.if this happens be aware that you may have run a tread cleaning tool to clean up the threads in the pipe.you may find it less aggravating to have a shop perform the ...

Question about 2008 Escape

1 Answer

...at the firewall infront of the passengers feet area for a crinkely short rubber tube, (maybe a downturned L tube) and clean it out with the pipe cleaner. May have to do this from underneath the

Question about 1990 Aerostar

1 Answer

...pump, automizer pump and then to injectors. Just remove pipe and blow air to clean, drain water, replace filter if cloged and also clean fuel tank if you find more dust inside the pipes or

...join permanently? Any suggestions? Sounds like, from your description, it is interference fit and has a sealant that seems to be leaking. Remove the pipe, clean the surfaces and reseat with

Clean the pipe with sandpaper and mix this epoxy putty and mould it around the area. It is sticky and sets like steel. I have used it for all sorts of jobs, even sealing a pinhole in a water pipe that

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Ford Focus
2000 Ford Focus

3,705 Questions

1998 Ford Explorer
1998 Ford Explorer

2,937 Questions

2001 Ford Focus
2001 Ford Focus

2,579 Questions

1999 Ford Taurus
1999 Ford Taurus

2,314 Questions

2004 Ford F150
2004 Ford F150

2,588 Questions

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85108 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...