Question about Nexxt WTMC 3300 Electric Dryer
...clean but the lint filter light is still flashing and now the dryer will not turn on. I have unpluged the dryer and checked out the exhuast duct in the back of dryer, everthing is clear. still not ...
Question about 3.81 cu ft WFMC530 1UC Nexxt 500 Plus Series Washer
...Clean your lint filter with windex, hot water and and soft bristle brush. If this doesnt work try running the until disconnected from the vent for a cycle to isolate the vent as your issue. Cheers! ...
...clean out the lint filter but nothing helps. My wife has a Bosch Premium dryer that had drying problems. The lint filter would get cleaned but the machine still did not operate correctly, as you ...
Question about 3.81 cu ft WFMC530 1UC Nexxt 500 Plus Series Washer
clean the lint filter on my Bosch Nexxt Premium Dryer. Apparently, I must not have put the lint filter flush with the base and now the door is locked. Is there a way to reset? Try unplugging it for an
...lint filter" When I try to use the dryer (Bosch Nexxt), i first turn the dryer to the setting desired (regular or perm press, and time) it immediately has the "lint filter" flashing. When I press the ...
Question about Nexxt WTMC 3300 Electric Dryer
Bosch Nexxt Dryer gets warm but laundry doesn't get dry. Dryer stops after about 10 min of running and starts ''beeping'' this could be a faulty moisture sensor. try running the dryer in a timed dry ...
lint filter is clogged due to the use of dryer sheets or fabric softener. You can try to clean the filter with Windex. If neither one of this suggestions resolves the issue there may be a problem with
Question about Nexxt WTMC 6300 Electric Dryer
...BOSCH NEXXT 500 ELECTRIC DRYER IS RUNNING ON 20 MIN AIR DRY BUT WITH NO HEAT. SOMETIMES BY SLOWLY MOVING THE DIAL WILL ALLOW THE HEAT TO RUN FOR A FEW MINUTES. THEN LINT SENSOR GOES ON. HAVE CLEANED ...
hi, my bosch nexxt 500 series indicates the lint filter is full, so we cleaned it and it still says that, but now it does not turn on? ...
Question about Nexxt WTMC 6500 Gas Dryer
...Bosch continues to give E01 error with lint filter flashing cleaned lint filter and exhaust and still doesnt work. Try cleaning out the compartment below the lint filter. There's a sensor in there ...
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions