...Density Error. Your bad sensor is not on the printer, but on one of the color toners. No sensors on toner cartidges. This error is usually a dirty sensor (a slotted opto sensor) on the transfer belt, ...
Question about CLX 3160fn All-In-One Printer
When printing, color comes out faded, and black copies are worse When a print a black and white text document straight from the computer, the quality is fine. Color printing is very faded, and color ...
...toner density. The normal should be in 3. Your toner nozzle might be clogged. Clean it with alcohol and warm water solution. Use a cotton or swab. See here:
...density. Other colors do not seem to be affected. Did you try to clean the developer blades in the imaging unit? The problem can be fixed by either replacing the imaging unit for $100+ or you can fix ...
option and just try the first. That should correct the problem for you. Good luck! Have you run the cleaning and calibration programs in the printer software
Question about CLP620ND Colour Laser Duplex Printer
...printer and visually observe the density of toner on the developer roller evenly. Some times the cleaning blade of ITB over come the problem. Before this try to adjust altitude and cleaning on EPM ...
...clean all sensor I cleaned the sensor input and output, but the problem is still there, is not completely out of paper and another paper by the pick up time is stretched, I do not think it's the ...
...density in setup. 2-remove toner cartridge and clean entire printer with air blower 3-replace toner cartridge Cleaning blades inside printer are likely fault. If printer has low use run off some more ...
Question about CLP 300 Laser Printer
...clean.
Is it time to call a service tech or is there something else that I can examine? Newsflash!!! Found the problem, after having this error several times, replacing parts, and even redirecting ...
Usually answered in minutes!
1,017 Questions
951 Questions
482 Questions
475 Questions
417 Questions