...Clean the ID sensor.If the developer life is expired replace the same ID sensor dirty or faulty ID sensor, Old drum, worn developer. When cleaning sensor be careful if you use a vacumcleaner can blow ...
any help greatly appreciated. toner density sensor is located in the developer unit. either the sensor is not reading cause something is covering it or it has poped so it can not reference any longer
...Clean the surface of the TD sensor. 4. Replace the TD sensor. If it becomes OK after the sensor is replaced, replace the developer of color related to the problem. If the problem is related to the ...
density. That is just a band-aid. try to replace the developer and if needed the opc and clean the drum unit and the ATDC sensor. You shouldn't have to readjust in the service mode. hi , how are you ,
...FW 780 Black and White Copier toner density sensor voltage is less than 0.5 volts or more than 4.5 volts. cLEAN THE 1) Toner density sensor 2) Flow of the developer at the toner density sensor ...
Question about FW 780 Black and White Copier
...remove the Cyan toner, pull the lever for the Density Sensor once, and replace the Cyan toner without any results. I have also carefully cleaned the machine Check the sensor properly and clean it ...
Question about Aficio 2015 Copier
...density sensor, first of all clean it with IP and check if problem persists go to SP mode and check in input check under modes,replace sensor if found defective,if problem resolves but recurs again ...
Question about Aficio Mp C2500 Color Laser - Printer / Copier / Scanner
...clean the sensor to clear the error code. Open right door. Density sensors (5) are located above the transfer belt behind the black plastic cover. Use a damp rag to clean. If you are trying to clear ...
Question about Aficio Mp C2500 Color Laser - Printer / Copier / Scanner
I have an error code SC400 on my Ricoh Aficio Machine the error code appear after every single print Clean the Image density sensor
Question about Aficio Mp C2500 Color Laser - Printer / Copier / Scanner
How to reset Ricoh mpc2030 color copier sc400error You have to clean the Image density sensor and restart the machine, code shall go by itself.
Usually answered in minutes!
629 Questions
382 Questions
267 Questions
215 Questions
218 Questions