...and release the key. check your battery cables take them off and make sure there is no corrosion, clean with a lil baking soda in a water to netrualize the acid. anti corrosion washers may help and ...
...the vacume lines if there is oil in them the switch has to be replaced and the lines should be cleaned out you should also check under the battery tray to make sure the boot is not ripped that ...
...clean the rail slider so that it will move freely and not bind up withthe rubber boot? I use a C clamp to compress the piston all the way in. are you sure you have the pistons flush? You put the pads ...
...also moves freely. I just did my daughters GM car. I had to pull back the rubber boots, thoroughly clean the pins and relubricate them with the correct lubricant. Worst case scenario, you may have
...the shaft, remove the entire unit and do it on the bench, put the shaft in a vise and knock the joint off with a soft headed hammer clean it repack it and install the boot with new grease, good ...
...clean air act of 1977 set limits as to the amount of each of these pollutants that could be emitted from an automobile. The manufacturers answer was the addition of certain pollution control devices ...
Usually answered in minutes!
1,363 Questions
1,123 Questions
1,127 Questions
1,104 Questions
838 Questions