boot and on the right hand side behind the rear seat is a small metal hatch. Remove it to gain access to the fuel tank. I would advise disconnecting the battery and then unscrewing the fuel pump cover
...dirty or leaking fuel injector, or the valves needed adjustment. I know the previous owner cleaned the injectors and replaced the coil assembly. Check engine light was on for the last 3 days ...
...clean out under the latch handle and then spray the spring and pivot points with lubricant (WD40 works). The lock will not work unless the handle fully releases. you will need to climb over back seat ...
boot lid underside and the small panel on the bottom where your knees would be ensure these are all clean and have a good contact. If no joy please get back to me. check the door plunger switch,it may
...clean so no debris will fall inside the cylinder. Remove plug wire by pulling it off by the boot and not the wire itself. Then with extension(s) spark plug socket and socket wrench, turn them ...
...BREAK INSIDE PLUG BOOT CAUSING SPARK PLUG NOT TO FIRE.REPLACE SPARK PLUG WIRES.CLEAN FUEL INJECTORS, CHANGE AIR FILTER,CHECK ALL VACUUM HOSES ON THE INTAKE MANIFOLD LOOKING FOR INTAKE VACUUM
...cv joint subaru justy 1987 subaru justy 1987 Is the axle removed from the car? If so cut the boot and clean the grease from around where the axle enters the joint. There should be a snap ring ...
boot(s), clean all components, re-grease with LM grease and replace.8) Reinstallation is the opposite of removal steps.Note: Take care when re-installing drive shaft to gearbox output shaft.
...boot replacement kit remove axle from suspension and trans. clean old grease out of failed axle, stuff new grease into cv joint and put new boot on shaft close to joint. fill the boot with the ...
Usually answered in minutes!
447 Questions
411 Questions
381 Questions
354 Questions
317 Questions