...boot/protector/cover of the sparkplugs. Corrective measures would require that said rubber boots be removed (one at a time) and compressed air sprayed to clear out the moisture/water. Additionally, ...
...boot and strip and clean it out with a soft brush of all the dust,rub the wiring plug connections with a soft black lead pencil.and iam sure it will work done two like this so far mine and old bobs
...boot,This plug is from the transit relay which is fitted when the cars leave the factory.This enables the car to be started and driven and to be stored without the battery going flat,But if those 2 ...
...for a dirty earth lead in boot or similiar? Removed lock solenoid actuator and tested off vehicle, cleaned up terminals and pulled some fuses and relays cleaning wherever I thought necessary, also ...
...clean around the sensors with a tooth brush and water DO NOT JET WASH! If this does not work check the connections to the module found in the bottom LHD Side of the boot, sometimes the plug ...
clean the boot lid where the seal makes contact and also the seal itself with a silicon spray polish (Mr Sheen) this should cure the problem if the water is entering via this seal. Also make sure that
boot open is coming up on the display window check your boot connection at the rear or clean the boot sensor at the back on the boot lid
...jump it and take it to auto zone and have the battery tested for free and the altanator, may need cleaning or something got left on. Why not put a new battery on ????. If you have access to the ...
...the door. do i need a new key fob??? My remote would not work for any function. Took it appart and cleaned the circut board with alcohol and now everything
...does not respond when pressed during this procedure it is FAULTY. you can try pulling apart and cleaning touch ...
Usually answered in minutes!
1,706 Questions
1,411 Questions
907 Questions
707 Questions
655 Questions