Questions & Answers for: GMC how do you clean boot

Question about 2000 Jimmy

3 Answers

...and release the key. check your battery cables take them off and make sure there is no corrosion, clean with a lil baking soda in a water to netrualize the acid. anti corrosion washers may help and ...

Ad

...boot and all so i know that all the lines are clear. try this , take out the THROTTLE BODY or what it looks like a carburator , if you havent clean this part in the past , it acumulates carbon ...

Ad

...clean the rail slider so that it will move freely and not bind up withthe rubber boot? I use a C clamp to compress the piston all the way in. are you sure you have the pistons flush? You put the pads ...

...also moves freely. I just did my daughters GM car. I had to pull back the rubber boots, thoroughly clean the pins and relubricate them with the correct lubricant. Worst case scenario, you may have

...the shaft, remove the entire unit and do it on the bench, put the shaft in a vise and knock the joint off with a soft headed hammer clean it repack it and install the boot with new grease, good ...

Question about 1992 Jimmy

2 Answers

...clean it check it connection if comes back on replace the mass air flow sensor P0101 mass air flow sensor poor performance. P0171 system lean bank 1. P0174 system lean bank 2. P0429 is catalytic ...

...clean use carb spray and a rag.Remove the air intake boot from the throttle body.carefully open the throttle plate with your hand,and clean out where the plate meets the body.(spray the carb spray ...

...boot click/snap onto the plug. Very easy for it to not be on there correctly, and cause mis-fires. #2 the like the first issue, the A/C issue is an easy fix. You unhooked the battery at some point, ...

boot off the throttle body, and can see the brass-colored throttle valve, grab your can of throttle body cleaner and a *clean* rag you won't mind getting dirty. Spray some throttle body cleaner on the

Question about 2005 Envoy

1 Answer

...Fluid Change & Filter Fuel filter Air Filter Plugs, wires/boots, cap & rotor if applicable Clean the MAF sensor with MAF spray. Clean any debris out of the air intake box. Run some seafoam

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 GMC Envoy
2004 GMC Envoy

2,225 Questions

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

2003 GMC Envoy
2003 GMC Envoy

1,368 Questions

2002 GMC Envoy
2002 GMC Envoy

1,418 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...