clanking noise where the belt is. this noise starts when i start the engine and keeps up the noise, but when i take the belt off the noise stops. but when I start or turn off my car whith the belt off
clanking noise while idling. Coming from idler. Any ideas to problem. Sounds to me like an idler pulley bearing. If that is for sure where the sound is coming from. If thats the case then time to swap
the back my guess would be a timing chain issue but that would be more of a clanking sound if its coming from the top end my guess would be a piston ring that broke and is scouring the wall of the cyc
engine makes a clanking noise, sounds like its the harmonic balancer Its probably the water pump. See if the belts are spining true at idle and also check to see if the weep hole on the bottom of the ...
noise at right rear of 2000 buick century lots of clanking and banging rear right side sounds like something loose at driving speed 80 to 120 k on the 4 lane most likely a blown shock/strut or mount ...
Question about 1995 Riviera
...clanking sound, then I felt a big **** and everything shut off now car won't start, or do anything. what does this problem sound I was on the highway do 70mph on cruise control, I just had a ...
Question about 1999 Park Avenue
clanking sound in park while running coming from under car on drivers side close to dash area. Vibrates and makes sound until the car reaches around 30mph and then quiets down.Runs just a little rough
loud clanking sound comming from valvetrain car ran fine then started missing and a clanking sound started in the upper area like its a valve train issue pull the rocker cover and see .
Question about 2002 Rendezvous
...it. When driving over bumpy road I hear a lot of clanking sound coming both from front and rear. What it may be? Suspension needs to be checked !ball joints ,shocks,struts ,tie rod ends and be
Question about 1991 Park Avenue
...you have done a bearing for the shaft it will not make a clanking sound as there is no pressure applied to the shaft basically a balance shaft is like a flywheel that takes vibrations out of the ...
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
1,091 Questions
904 Questions