Questions & Answers for: cl 175 poor idle

...cl idle started acting up. It idlles fine for about a minute after start, then it idles up and down from about 700 to 1200. Sounds like it starts to die, idles down, and then runs back up to 1200. ...

cl high idle, self rev, overheat, started same time my 97 acura 2.2 cl started idling at 2k when it was really cold outside, now its not so cold , but it revs by itself and idles at 1200 when in drive

...PRESS DOWN ARROW KEY ¯ , SELECT DATE/TIME, KEY IN CURRENT DATE MM/DD/YYYY, PRESS GREEN ENTER KEY, KEY IN CURRENT TIME HH/MM/SS, PRESS GREEN ENTER KEY, PRESS RED CLEAR KEY TO EXIT TO IDLE

Cl just bought today.It has an erractic idle that is so bad that just sitting it will idle from 600 to 1400 rpms but never staeady.The battery light also flashes. The guy Ibought it from is a coworker

...cl 175 Set the points to .015 clearance when the points arm is at the highest point on the camshaft lobe. Now use a timing light to set the timing. Set the timing at idle by rotating the points base ...

...cl 2.2 Your idle should pretty much be set by the computer and shouldn't change to much unless some repairs have been or you have another problem. In any case below are the instructions on ...

poor coolant flow (no heat at idle approx 750rpm). changed t-stat. Comp. chk 1-180, 2-160, 3-160, 4-175 (specs say 198psi). looks like head gasket might be leaking between c the car only has 89k miles

...cl 175 from 1976 what are the carb settings ? Hi Leroy, there are two setings, idle screw which if i rember corectly is bigger than the air fuel mixture screw. First start engine and warm it up to ...

...cl 2.2 and when I start my engine it the rpm idles to 1. Why is that? unless the car is at operating temperature , the engine rpms on start is hiogher the at run as the ECM has a higer setting for ...

2002 Dodge Stratus 2.4L. I replaced the timing belt. Why does it run poorly? Compression test #1 185 #2 175 #3 175 #4 180 lbs I am sure i have the belt on correct. It ran good before I started on it. ...