...ground circuit is open PCM has failed Trouble Code: P0340 No Camshaft Position Sensor Circuit Failure Trouble Code Conditions:Engine cranking or running, system voltage over 10v. The PCM detected CKP ...
Question about 2007 PT Cruiser Touring Hatchback
GROUND CIRCUIT PCM TP SENSOR OPERATION HIGH RESISTANCE IN (K6) TP SENSOR 5 VOLT SUPPLY CIRCUIT RESISTANCE TO GROUND IN (K6) TP SENSOR 5 VOLT SUPPLY CIRCUIT TP SENSOR HIGH RESISTANCE IN (K22) TP SIGNAL
...ground for the cooling fan! Temperature sensor for the cooling fan circuit! There are 2 relays for the radiator fan because it has 2 speeds and 2 windings in the fan motor. The relays are in the fuse ...
what cause hard code poo31? code poo31 I reset the Ecm,code comback in 5seconds,I replace both oxigen sensors same problem again I check grounds, powers, heather circuit is ok, Try with another ecm
...Replaced ecu and o2 sensors could this be a ground issue? You have to check at the O2 sensor connectors that there is power and ground to the heater circuit. This will minimize you diagnostic
Question about 2006 PT Cruiser
motor by hand and see if it moves freely and sounds quiet. If the fuse still blows you need to continue to inspect the circuit and look for bad spots in the wire where the 12 volts can short to ground
Question about 2001 PT Cruiser
...ground wires and clean connections between battery ground and frame / car body which completes all
...ground • Stepper motor coil circuit(s) is shorted to voltage • Stepper motor has failed • PCM has failed Engine running; system voltage over 11.5v, and the PCM detected an incorrect voltage on one or ...
Question about 2001 PT Cruiser
...GROUND CIRCUIT OPEN TRANSMISSION CONTROL RELAY CIRCUIT OPEN TCM PIN 16 TO TCR OPEN OR BAD CONNECTION TCM PIN 17 TO TCR OPEN OR BAD CONNECTION TRANSMISSION CONTROL RELAY DEFECTIVE NO OUTPUT FROM ...
Question about 2005 PT Cruiser
...circuit or else it would not start from pushing could be a problem battery ( have a load test done ) bad ground points , faulty starter relay if the ignition switch is not operating right when it is ...
Usually answered in minutes!
1,198 Questions
1,147 Questions
1,007 Questions
816 Questions
677 Questions