...ground circuit is open PCM has failed Trouble Code: P0340 No Camshaft Position Sensor Circuit Failure Trouble Code Conditions:Engine cranking or running, system voltage over 10v. The PCM detected CKP ...
Question about 2007 PT Cruiser Touring Hatchback
GROUND CIRCUIT PCM TP SENSOR OPERATION HIGH RESISTANCE IN (K6) TP SENSOR 5 VOLT SUPPLY CIRCUIT RESISTANCE TO GROUND IN (K6) TP SENSOR 5 VOLT SUPPLY CIRCUIT TP SENSOR HIGH RESISTANCE IN (K22) TP SIGNAL
...circuit(ground) or driver. The primary function of the driver is to supply ground for the object that is being controlled. Each driver has a fault circuit that the PCM monitors. When the PCM turns a ...
...ground circuit open[*]Output speed sensor signal circuit short to ground[*]Speed sensor ground circuit short to ground[*]Output speed sensor signal circuit short to voltage[*]Speed sensor ground ...
...of the ground at the same time. If no voltage try another good ground if battery voltage is found with the different ground you need to repair the ground circuit. If no power repair the power
Ground Circuit of the Coil on Plug connector that you're testing. * No Power in only one Ignition Coil Without 12 Volts, the Coil-on-Plug Ignition Coil will not work, thus you have just eliminated
Question about 2005 300
...Ground circuit and the (G6) Engine Oil Pressure Signal circuit.NOTE: Engine Oil Pressure voltage should change from approximately 4.5 volts to less than 0.5 of a volt. Is the voltage reading ...
Question about Air Intake & Fuel Delivery for Chrysler 300 AWD Sedan
CIRCUIT SHORT TO GROUND(K236) SRV CONTROL CIRCUIT OPENSHORT RUNNER VALVE SOLENOIDPCM Trouble Code: P2008Short Runner Solenoid Circuit Malfunction Possible Causes: S/R solenoid control circuit is openS
Question about Air Intake & Fuel Delivery for Chrysler 300 AWD Sedan
...ground circuit is openEGR solenoid control circuit has a problem.EGR valve actuator loose, sticking, blocked or improperly grounded.EGR Sensor is damaged or has failed.Intermittent condition.PCM has ...
...is open or shorted to ground or to battery voltageCMP Sensor ground circuit is openCMP Sensor is damaged or has failedCKP Sensor is damaged or has failedPCM has failed.Here's a link to your
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,198 Questions
1,079 Questions
1,173 Questions