Questions & Answers for: Apex Digital circuit board

...circuit board on the right hand side is either cracked or the soldering came loose, I took mine apart and found it by mistake, everytime I pulled up the board i had picture again, so I propped up the ...

...and small and are soldered through the board.. This will tell you which circuit the problem is in by knowing which ones are shorted. If I were a betting man I would look at the convergence amps

circuit board that contains the STK convergence modules. They're on the center circuit board attached to an aluminum heat sink that's about 8" long and 6" tall, about dead center in the circuit board.

...it helps. http://www.vancebaldwin.com/products/?APX&start=101 fix the board. i recently had a lighting hit my tv and found the MOV area board circuit copper fried. I rewired and it works fine. ...

...circuit board on the Apex LD1919? Apex LD1919 blinking green power light. Removed all screws from rear of tv, but I cannot get the two halves separated. This is to possibly replace the (2) blue ...

...circuit board itself. Most often however, the symptom described is a result of failed ELECTROLYTIC CAPACITORS on the power supply circuit board.  One quick way to check this ...

...or one of its support components. In these sets the components are mainly surface mount types. Normally, the service centre will change the complete circuit board containing the input

...board will be a part of the panel itself, and will be a built-in type inside the LCD panel. If so, they can't be replaced. In this case; a panel replacement is the only repair. For some other models, ...

...power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board itself. If so; the main board should be

...circuit will be integrated at its main board itself. If so; the main board should be replaced. To some models of sets, all these section circuit will be integrated at its main board. If this is the ...