Questions & Answers for: Andis circuit board

...circuit board on the cable terminals, you need to measure the voltage from the circuit board and the resistance on each armature segment as these can blow the circuit boards. If the circuit board is ...

...circuit board now the motor unit should come away from the lower cassing. remove the clips holding the carbon brushes in place beware there are springs behind these clips, remove the two long black ...

connect to anything, the only contact which matter are the copper wires connecting the circuit board to the Carbon brushes. This may be as simple as a faulty cable check for power to the circuit board

...changes on it's own and sometimes it only has one speed. wondering if it is the motor or switch? Neither the circuit board need jacking up with a washer either side or worst case a new

circuit board burn out in Andis AGP trimmers? Clippers quit in middle of trimming a dog. Disassembled, found burnt out circuit board, ordered a new one, installed, turned clipper on and it ran poorly,

...circuit board, with the switch, and they worked when I plugged them in but then they stopped working and froze. I can still here a low humming, so they are getting power, but the motor seems to be ...

circuit board was gone. I have ordered a new circuit board and changed it but still the same problem,my question is the armeture faulty or maybe the new board ive bought is faulty? Thanks. Maintenance

clippers wont turn off? Sounds as though the switch is faulty on the circuit board you can purchase new Andis parts here Dog Clippers

Clipper will only work on slow speed could it be circuit board Please call the andis customer service dept at 1-800-558-9441 to discuss repair for this unit.