...adjust the choke to where it will stay in without holding it by turning the rubber piece behind the choke clockwise towards you until the choke stays out on its own. You can adjust this so the choke ...
Question about 20 Hp 42" Deck Lawn Tractor
...adjust choke. If you raise hood and adjust your throttle you will see that when you press up to choke that it actually hits & pushed in choke. But when you back off if it is like mine the choke ...
Question about 21 hp 42 in. Deck Yard Tractor - CA Model
...when you take choke off Hi there, The choke cable needs adjusting. There is a strap holding the sleeve on the carb. loosen it and adjust the choke position, then tighten it up again. Thats it ...
...If that is the case then reconnect, replace, or adjust as necessary. If the choke lever and carb choke system is moving correctly then the problem may be in the carburators themselves. Good ...
...and recheck performance...If choke stays on to long after warm up (idles fast) adjust the choke toward open or lean position. Try no more than 2 notches either way between tests...Hope this
Question about 21 hp 42 in. Deck Yard Tractor - CA Model
adjust when the choke engages and/or disengages. This is more of a timing of the choke adjustment, so keep in mind that this will also change how long the choke stays on as the engine warms up. 2. You
choke not operating properly won't start cold with the choke on. It will start when it is warm out, but when choke is applided, it chokes out. I pulled cable out and plunger is working properly. Any ...
...Choke is an adjustment to air intake to adjust fuel/air mixture and is heat related. Do not fully open choke as soon as it starts. Gradually open as the trimmer warms up. If a happy medium can not be ...
Question about 2005 Big Bear 400 4x4
...adjust the choke cable? Hi Jim: Make, Model Year Carb? Probably yes since you mention choke - Idle is adjusted by screwing the throttle stop screw in or out. - Choke cable is adjusted by slacking off ...
Question about 2005 Big Bear 400 4x4
I have a craftsman 3.3ci chainsaw when started it runs very high on choke but when I depress the choke switch in the saw dies but will run fine when choked I've cleaned the carb replaced the fuel ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions