Questions & Answers for: chevy truck map sensor problems

...map sensor for a Chevy S-10 goes to the ecu? Well after looking it up it's the the map input wire is light green on both 4 and 6 cylinder models. On a 4cyl the map has black gray and light green, the ...

Ad

...chevy trailblazer we changed the MAP sensor, the camshaft position sensor and the crankshaft position sensor. We also replaced the connecting rod bearings because of a bad knock. The bearing #3 was ...

Ad

...Chevy Truck , Stock Radio , Whining noise thru the speakers seems to increase with enginge speed. Radio Grounded ? or ? Sounds like you have a capacitor problem.It could be a number of issues , but i ...

...chevy cavalier it is idling real high it is idleing very high Check your map sensor. Your iac sensor and your throttle body position sensor. Then check vacuum. I'm having a similar problem and I've ...

...Chevy C2500 2 Wheel Drive, 350 Truck We have replaced everything but the knock sensors and the chip that goes to the computer and we are still having the same problem. The problem is that the truck ...

...chevy duramax diesel 6.6 Truck idels fine underload wil not turn more than 2000rpm's replaced map sensor , still problem exists after running 10 hr's clean 2007 chevy duramax diesel 6.6 Truck ...

Question about 1995 C2500

1 Answer

Chevy Lumina and the check engine light has been coming on about 20 minutes after I start driving. If I turn the car off and turn it back on it's gone for another 20 minutes. The codes it spit out

...chevy 1500 4x4 cuts out at highway speeds After having a ball joint replaced, truck started cutting out at highway speed. It will catch itself and keep going. Usually after hitting a good bump. Also ...

Question about 1986 Chevy

1 Answer

...map sensors on my truck and nothing has changed . truck runs better with out the map sensor plugged in . Did you ever thing that it could be a wiring problem ? Or the engine computer ? Maybe just ...

Question about 1986 Chevy

2 Answers

...chevy blazer 4×4 4.3 vortec wont start after i changed map sensor. But i touched map wires together on misyake bcuz i didnt tape off bare wires yet... since then my blazer just wont start... it wont ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...