...ground and remove them then take brake clean and spray the sensor pick ups to remove any dirt or brake dust. also make sure that the plugs and wires to the sending units are ok also they should be no ...
...wire that the insulation got wore thru in the colume. Unhook break light switch and try the turn signals and hazards again and see what happens, maybe you can isolate it that way. Also if you havent ...
...wire.now put a red clip one one and a black clip on the other. you make up a ground tester and a positive tester what ever you do don't let them touch each other.while your testing.. First i want you ...
...ground on the harness going to the brake lights. It's most likely going to be the switch located in behind your brake pedal. It's an easy fix and you most definitely can do it yourself. there are a ...
...gmc jimmy. no brake lights are working, i have turn signals, 4 ways, tail lights. checked fuse and light bulbs,all ok. can't find a brake switch on brake pedal inside the passenger compartment. is ...
...checking and adjusting timing that have been updated during production. The information contained on the label should always be used if it differs from these instructions. On most HEI systems, the ...
wire keeper one on each side of the vehicle for each pigtail. You need to jack up the front end so the tires are off the ground . Disconnect the connector at the frame then siin the wheel . the sensor
Jimmy. Checked plug. seems right. makes no sense......... Standard wiring colors are as follows: 4-Way 5-Way 6-Way 7-Way Green Yellow Brown White Red Blue Purple Right Turn & Brake Left Turn &
Question about 1999 Blazer
...wire harness diagram and troubleshoot the harness for ground shorts and any burnt wires..also check panel on driver side on the side of dash for other fuses that might be burnt out .. good luck and ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions