...carrying the roller-check toner motor is pluged firmly in its socket-go to rear frame and check toner selonid is working and in good condition-check gears that drive toner roller in good
...Check Toner Sensor: The printer has sensors that detect the toner level. Sometimes, these sensors can become dirty or malfunction. Locate the toner sensor (usually a small window or sensor on the ...
...Check the toner hopper exit slider is opening fully when the PCU is inserted. I had one of these 'add toner' faults today and it was the toner hopper all clogged up inside. The side bit where the ...
...developer unit Causes: Defective toner motor. Check procedures/corrective measures: Replace the developer unit Causes: Defective engine PWB. Check procedures/corrective measures: Replace the engine ...
...check the toner hopper .toner is not being fed into the developer module at set rate.clean the hopper by blowing the toner and check the toner screw motor for rotation and do check when u install ...
...check the transfer belt toner removal section is OK. Also check the gears on the left side of the waste toner box is ok and the machine gears ok not jammed. could also have a jam in the internal tube ...
Question about Aficio 2016 Black and White Copier
...check if the toner motor is rotating, also check if the buttom of the toner unit is designed to fit the toner motor. finally check the td sensor . this may be the major cuase of this problem. good ...
Toner) to check if the Toner Container Inner Cover opens normally (damage, slide of shaft area, etc.). ? 2. Check if the Toner Container Inner Cover Sensor is soiled and the installation of the sensor
Question about imageRUNNER ADVANCE C5051
...Check Toner Cartridge Gear: Ensure that the toner cartridge gear is rotating freely and is not damaged. If the gear is not turning properly, it can cause toner supply issues. Inspect Developer Unit ...
...Check Toner Cartridge: Verify that the toner cartridge is correctly installed in the copier and that the seal or protective strip has been removed before installing. Ensure that the cartridge is ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions