Questions & Answers for: Toyota 4Runner check timing

engine check light and vsc track off my toyota 4runner 2003 model, has being showing engine check. the light comes and go off at time, but for the past two weeks now it has remain permanently on. the ...

...4cyl. Engine fan runs all the time but can spin it by hand when motor is off. Had a diagnostic check done and no codes were found? If the A/C is on, it is supposed to run all the time. If the

...was wrong. but its is, what can it be ??? You need to verify that the cams are timed, Yous ay you checked timing, do you mean cam timing or ignition timing. the ignition timing is based on the left ...

...the engine. Code 25 timing over retarded bank # 2, check ignition timing, make sure distributor was installed at # 1 cylinder, if timing belt replace make sure it was align right at timing

Check all fluids and belts.Replace the timing belt.Change engine oil and filter,check air filter.Test the coolant for protection level.You may won't to change the transmission fluid and filter at this

...ran a little ruff the next day wont start. cranks ok spark is good, fuel pressure good, replaced cold start injector still no start have you checked timing? also, check compression in all 6

...check the ignition timing. The 22R-E should read 5° BTDC, 3VZ-FE should read 10° BTDC and the 3F-E should read 7° BTDC. All of these readings are at idle. On 3-FE engines, remove the ...

...on. i put them back on and now the engine wont run it will stars for a second but then die. i checked compression in all cylinders and it was around 150 i checked fuel pressure and it was 45 ...

timing How to check and adjust ignition timing: toyota 3.0L - YouTube ? 1:58 https://www.youtube.com/watch?v=pOdFqKxPviA Dec 3, 2014 - Uploaded by SCOTT BROWN shown is a 1990 Toyota pick up. It should

...check engine light until I retarded the timing like the tech told me that it failed because the timing was to far advaced 10 degrees..when I changed it with jumper in 10d retarded then drove it ..the ...