Questions & Answers for: Dodge Ram 1500 check timing

need to know when is normal timing to change out front and rear break pads. it is definately time to check them. Usually every 30K is a good interval to check them. Especially if lots of city driving

Ad

Question about 1998 Ram 1500 4WD

1 Answer

...timing setting for 1998 Dodge Ram 1500 Put the number one piston at TDC (top dead center) Pull the cover off the distributor and check to see if the rotor is pointed at the number 1 plug wire. If not ...

Ad

...voltage & continuity. Timings also been checked. There is no trouble code you can check your map sensor your egr valve and also have your timing checked it sounds as if your timing is off a

abs light comes on at times and at times the abs light comes on at times and at times the pedal will get hard when applying and trys to push the pedal back up what could this be i have replaced the ...

...check the timing cause it jumped a gear how to check the timing cause it i think it jumped a gear. how can i check it to make sure it is in correct timing. were is the position of the rotor sit? To ...

Question about 2007 Ram 1500 Quad Cab Sport

1 Answer

signal sometimes cuts out for 10 seconds occasionally. Check for a loose connection or bulb. I would check the fuse box first. Then the bulbs. some times if loose it can cause a lap or delay in time.

Question about 2001 Ram 1500 Truck 2WD

2 Answers

...check for timing.  The timing belt might be slipping and if your vehicle is a interferrence motor and you have not changed the timing belt around every 50 to 60 thousand miles would destroy the ...

Question about 2001 Ram 1500 Truck 2WD

1 Answer

...check the timing by pulling plug #1 and bring it to top dead center and lift the cap and make sure the rotor is hitting #1 becareful if you set the timing not to get it 180degrees off . If you have a ...

dodge 2004 1500 my check engine light comes on from time to time saying no oil presure on my gadge but when I check the dip stick it is full your pressure sending unit needs replaced,

...has a miss,compression is at 140,acts like timeing is off or bad points,need your advise,i'm disable so it's hard to mess with distributor. check all cylinders for compression, and check your

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...