Questions & Answers for: Oldsmobile check timing

...Check for excessive play in the distributor shaft. If it checks out, Re-install the distributor and place a socket at the crank bolt. With the dist. cap off, rotate the engine backwards. While ...

...check. If it is the timing, could you tell me how to check it. Thanks gary Id be suprised if its the timing as it was fine when you turned vehicle off and that isnt enough to make your timing ...

...check for spark from the coil, or coil packs, if that checks out ok, have the crank and cam shaft position sensors checked, timing belt, computor. I know it's a pain, but I have worked on cars for 40 ...

timing, you name it. i ran across this o-ring today on one of the injectors and its messed up bad! could this cause my problem?? definetly, you have to check injectors electrically as well as physical

...what could it be? Check egr valve, check pvc valve, check head gasket, check air filter, timing timing out of adjustment, burned valves or leaking, cam shafts could be worn, check fuel

...do I check next.this is for a 1993 cutlass ciera,3.3 motor,fuel injected. Check timing. Shoot a timing light at the crank. If the mark is jumping around a lot, your timing belt/chain has jumped a

TIMING IS NOT ADJUSTABLE..MOST LIKELY ITS THE CRANKSHAFT POSITIONING SENSOR..THEY ARE NOTORIOUS FOR GOING OUT ALL THE TIMES ON THESE ENGINES...IVE REPLACED MINE TWICE...CHECK ELECTRNIC MODULE FIRST,,O

...to make sure the rotor turns as the engine is cranked. If not, check the timing. If the distributor has been replaced and the rotor turns, and you still get no spark, replace the spark plug

...check engine timing on V6 3.3L Cutlass Ciera Oldsmobile? cannot adjust or check engine timing it is not adjustable it's a c3i coil and module system there is a timing on timing chain adjust with mark ...

...timing advance, not adjustable. Um... Such hesitation could be from old, worn spark plugs, old, worn plug wires, a dirty air filter, a dirty fuel filter. (Is your check engine light on when running? ...